KTM Fan on the BRP

Here is the fan I ordered from www.ktm-parts.com, it fits up nicely. I then made a bracket out of Aluminum that I picked up at my local ACE Hardware store. It worked out really good. Still have to wire it up to a switch, but I am waiting for the Rectifier to come in from Baja Designs. Also as you can see I shaved part of the fan so the Acebis tank will fit nicely too without rubbing.

Looks good.

Here's more for those who are thinking of this mod...Great switch ideas etc.

radiator-protection

radiator-fan-install

modette wrote:Here is the fan I ordered from www.ktm-parts.com, it fits up nicely. I then made a bracket out of Aluminum that I picked up at my local ACE Hardware store. It worked out really good. Still have to wire it up to a switch, but I am waiting for the Rectifier to come in from Baja Designs. Also as you can see I shaved part of the fan so the Acebis tank will fit nicely too without rubbing.

What is the thickness of this setup, I want to measure to see if it would fit with my Clarke 4.3 tank?

I have no clue...I thought I read over on ADVrider that it would not work with the Clark tank, I could be wrong though.

I read that as well which is why I was asking...Didn't know if it was slight enough to heat the tank and push it in a little like mounting the FCR carb or if it required too much. As well I don't know if I believe that it doesn't work since comparing to my stock tank... it doesn't protrude too much (just eye-balling it)